// sumber: https://github.com/adafruit/Adafruit_MCP9808_Library/blob/master/examples/mcp9808test/mcp9808test.ino

#define SDA 15  // sesuaikan dengan port yang dipakai untuk SDA dan SCL
#define SCL 13

#include <Wire.h>
#include "Adafruit_MCP9808.h"

// Create the MCP9808 temperature sensor object
Adafruit_MCP9808 tempsensor = Adafruit_MCP9808();

void setup() {
  Wire.begin(SDA, SCL);
  Serial.begin(115200);
  while (!Serial)
    ;  //waits for serial terminal to be open, necessary in newer arduino boards.
  Serial.println("MCP9808 demo");

  // Make sure the sensor is found, you can also pass in a different i2c
  // address with tempsensor.begin(0x19) for example, also can be left in blank for default address use
  // Also there is a table with all addres possible for this sensor, you can connect multiple sensors
  // to the same i2c bus, just configure each sensor with a different address and define multiple objects for that
  //  A2 A1 A0 address
  //  0  0  0   0x18  this is the default address
  //  0  0  1   0x19
  //  0  1  0   0x1A
  //  0  1  1   0x1B
  //  1  0  0   0x1C
  //  1  0  1   0x1D
  //  1  1  0   0x1E
  //  1  1  1   0x1F
  if (!tempsensor.begin(0x18)) {
    Serial.println("Couldn't find MCP9808! Check your connections and verify the address is correct.");
    while (1)
      ;
  }

  Serial.println("Found MCP9808!");

  tempsensor.setResolution(3);  // sets the resolution mode of reading, the modes are defined in the table bellow:
  // Mode Resolution SampleTime
  //  0    0.5°C       30 ms
  //  1    0.25°C      65 ms
  //  2    0.125°C     130 ms
  //  3    0.0625°C    250 ms
}

void loop() {

  // Read and print out the temperature, also shows the resolution mode used for reading.
  Serial.print("Resolution in mode: ");
  Serial.println(tempsensor.getResolution());
  float c = tempsensor.readTempC();
  float f = tempsensor.readTempF();
  Serial.print("Temp: ");
  Serial.print(c, 4);
  Serial.print("*C\t and ");
  Serial.print(f, 4);
  Serial.println("*F.");
}